Diamond Blade Trouble Shooting Excessive wear
Symptom:Excessive wear of diamond blade Cause:a.Using the wrong diamond blade on highly abrasive material (example: glazed tile blade on concrete block). b.Lack of sufficient coolant to the blade. Often detected by excessive wear in the center of the segment (note: in both above cases, diamonds will usually be highly exposed). c.Wearing out-of-round accelerates wear. Usually can be caused by bad bearings, worn shaft or using a blade too hard for the materials being cut. d.Insufficient power caused by loose V-belts, inadequate voltage, or improper RPMs. Remedy:a.Consult the dealer or manufacturer for the proper blade specification for abrasive material. b.Clean up water system. Make certain water pump is functioning properly. ...