(JDRDIATOOL@163.COM)Diamond blade,polishing pad, hole saw,drill bit, grinding wheel, cutting tools

Symptom:Excessive wear of diamond blade Cause:a.Using the wrong diamond blade on highly abrasive material (example: glazed tile blade on concrete block).           b.Lack of sufficient coolant to the blade. Often detected by excessive wear in the center of the segment (note: in both above cases, diamonds will usually be highly exposed).          c.Wearing out-of-round accelerates wear. Usually can be caused by bad bearings, worn shaft or using a blade too hard for the materials being cut.          d.Insufficient power caused by loose V-belts, inadequate voltage, or improper RPMs. Remedy:a.Consult the dealer or manufacturer for the proper blade specification for abrasive material.              b.Clean up water system. Make certain water pump is functioning properly.     ...

The application fields of vacuum brazed diamond tools 1. Suitable for DIY cutting in the western families,for it’s universal specialities. 2. Could use in strong cutting,drill,and expecially in the special spot like fire emergency,for the coherence and high convexity of diamonds. 3. Could cut the materials which is easily blocked like resin wind-power blade,ferrous metal materials,for its ample place for scraps 4. Cutting efficiently of concret which with high density of rebars,castiron pipe by government,two side rebars on the tracks high speed rail 5. For the super hard granites,ceramics and other materials which could not be easily cut by the electroplated/sintered diamond tools. Vacuum Brazed diamond cup wheel Vacuum Brazed diamond cup wheel VB diamond tools

PCD Milling Insert, Turning insert, tools

1.Six dots concrete polishing pad  for CHA machine from Taiwan,Klindex from Italy, HTC machine and SPE from the UK with high performance 2. Size:60*10 3.Effetive in the process of dry grinding and polishing concrete floor  

Symptom: Diamond blade won't cut Cause:a. Diamond Blade is too hard for materials being cut (examples: block or general purpose blade being used for extended period on hard brick. Asphalt diamond blade being used to cut hard concrete).          b. Insufficient power to permit diamond blade to cut properly (loose V-belts, low voltage, motor lacks horsepower).         c.  diamond Blade has become dull because of continuous use on fairly hard or vitrified material.         d.  Diamond Blade segments appear to still have plenty of life, but diamond blade won’t cut. Remedy: a. Consult dealer or manufacturer for proper diamond blade to cut materials on job.                b. Check belts, voltage, horsepower.               c. Dress with abrasive material until ...

Symptom: Bore hole out of round Cause:a.Saw arbor badly worn due to improperly seated blades.           b.Blade flanges not properly tightened permitting blade to rotate on shaft.           c.Blade flanges or arbor shaft worn and not providing proper blade support. Remedy:a.Be certain the blade is properly seated on arbor before tightening flange.              b.Always wrench tighten the arbor nut. Never hand tighten. Always use hex nuts. Never use wing nuts.             c.Check blade flanges or arbor shaft for wear. Both flanges should be no less than that recommended by the manufacturer. Replace worn parts. Turbo segmented diamond blade