Diamond blade Trouble Shooting Uneven Segment Wear
Symptom:Uneven Diamond Segment Wear
Cause: a. Diamond Segments are worn on one side, reducing side, reducing side clearance. It is usually caused by misalignment of the saw or a lack of sufficient water on both sides of the diamond blade.
b . Diamond Blade is worn out-of-round due to bad bearings, worn arbor or excessive dulling condition. See section on excessive wear.
Remedy: a.Check saw alignment. Clean water system, making certain that water is properly applied to the leading edge of the blade flanges. Check to see if pump is supplying sufficient, even water.
b.Replace bearings or worn arbor as required
Cause: a. Diamond Segments are worn on one side, reducing side, reducing side clearance. It is usually caused by misalignment of the saw or a lack of sufficient water on both sides of the diamond blade.
b . Diamond Blade is worn out-of-round due to bad bearings, worn arbor or excessive dulling condition. See section on excessive wear.
Remedy: a.Check saw alignment. Clean water system, making certain that water is properly applied to the leading edge of the blade flanges. Check to see if pump is supplying sufficient, even water.
 |
| Turbo segmented diamond blade |
Comments
Post a Comment
Please make some comments on them. Thanks!!!