(JDRDIATOOL@163.COM)Diamond blade,polishing pad, hole saw,drill bit, grinding wheel, cutting tools

The application fields of vacuum brazed diamond tools 1. Suitable for DIY cutting in the western families,for it’s universal specialities. 2. Could use in strong cutting,drill,and expecially in the special spot like fire emergency,for the coherence and high convexity of diamonds. 3. Could cut the materials which is easily blocked like resin wind-power blade,ferrous metal materials,for its ample place for scraps 4. Cutting efficiently of concret which with high density of rebars,castiron pipe by government,two side rebars on the tracks high speed rail 5. For the super hard granites,ceramics and other materials which could not be easily cut by the electroplated/sintered diamond tools. Vacuum Brazed diamond cup wheel Vacuum Brazed diamond cup wheel VB diamond tools

PCD Milling Insert, Turning insert, tools

1.Six dots concrete polishing pad  for CHA machine from Taiwan,Klindex from Italy, HTC machine and SPE from the UK with high performance 2. Size:60*10 3.Effetive in the process of dry grinding and polishing concrete floor  

Symptom: Diamond blade won't cut Cause:a. Diamond Blade is too hard for materials being cut (examples: block or general purpose blade being used for extended period on hard brick. Asphalt diamond blade being used to cut hard concrete).          b. Insufficient power to permit diamond blade to cut properly (loose V-belts, low voltage, motor lacks horsepower).         c.  diamond Blade has become dull because of continuous use on fairly hard or vitrified material.         d.  Diamond Blade segments appear to still have plenty of life, but diamond blade won’t cut. Remedy: a. Consult dealer or manufacturer for proper diamond blade to cut materials on job.                b. Check belts, voltage, horsepower.               c. Dress with abrasive material until ...

Symptom: Bore hole out of round Cause:a.Saw arbor badly worn due to improperly seated blades.           b.Blade flanges not properly tightened permitting blade to rotate on shaft.           c.Blade flanges or arbor shaft worn and not providing proper blade support. Remedy:a.Be certain the blade is properly seated on arbor before tightening flange.              b.Always wrench tighten the arbor nut. Never hand tighten. Always use hex nuts. Never use wing nuts.             c.Check blade flanges or arbor shaft for wear. Both flanges should be no less than that recommended by the manufacturer. Replace worn parts. Turbo segmented diamond blade

Symptom:Overheated Cause: Adequate coolant was not provided. Remedy:Check the water supply for adequate volume and for obstructions in the water system. Use dry blades ONLY for shallow cutting (1-2” deep) or step cutting. Allow blade to run freely every 10 to 15 seconds in order to increase cooling air flow. For more information, please click here Diamond blade